Skip to content
Meter box on a Sutherland Shire home with new consumer mains in conduit
Level 2 electrical

Consumer Mains Upgrade Sutherland Shire

Replacing tired and undersized mains from the bracket to the meter board, with fittings that stand up to salt air.

Get a free quote

Takes a minute. We'll call you back, usually the same day.

No obligation. Your details stay with us and are never sold or shared.

Consumer Mains Upgrade in the Sutherland Shire: step by step

  1. Check the existing runWe look at the bracket, the cable route and the meter board, and check the cable size and condition.
  2. Size it for the Shire lifestylePool pumps, heat pumps, ducted air, a granny flat or an EV: we size the new mains for what's coming.
  3. Replace on the dayWe notify Ausgrid, isolate the supply and swap the mains, terminating both ends.
  4. Test and certifyWe test, reconnect and give you the certificate of compliance.

Consumer mains are the heavy cables between the point where the Ausgrid network attaches to your house and your meter board. Everything in the house runs through them. In the Sutherland Shire, most homes were built between the 1950s and the 1980s, and many still have the mains they were connected with. Since then the Shire lifestyle has added a lot of load: pools and heat pumps, ducted air conditioning, granny flats, workshops, solar and batteries, and now EV chargers.

What we find in Shire homes

The typical setup is a bracket or raiser on the front of a brick or weatherboard home, mains running through the eave or down the wall, and a meter box near the front door or down the side. On 1960s and 70s homes in Miranda, Gymea, Jannali and Engadine the mains are usually PVC, often smaller than today’s homes need. On older cottages in Sutherland and Como we still see rubber-insulated cable that has cracked with age.

Near the coast in Cronulla, Woolooware and Kurnell, there’s another problem: salt. Glands, saddles and terminations at the meter box corrode, and moisture gets in where the cable enters.

Signs your mains need looking at:

  • Lights dim when the pool pump, oven or air conditioning starts
  • The meter box is warm or smells hot
  • Corrosion or green staining where the mains enter the board
  • Your pool, solar or air conditioning installer says the supply is too small

How the upgrade works

We trace the existing mains from the bracket to the meter board, check what they feed, and size the new mains for your full load with room to grow. If a granny flat, a big heat pump or a three phase power upgrade is likely in the next few years, we plan for it now.

On the day, we lodge the notification with Ausgrid, isolate the supply, pull out the old cable and install the new mains, usually in conduit. Both ends are terminated with fittings suited to the location, the installation is tested and the power is restored. You get a certificate of compliance.

Brackets and raisers at the same time

On many Shire homes the bracket or raiser is as old as the mains, and near the water it’s often rusted. If it needs replacing, we combine the job with a point of attachment upgrade so it’s done in one visit. If you’d rather lose the overhead line altogether, an overhead to underground conversion replaces the line and the mains in one go.

Granny flats and second dwellings

Granny flats are common on the bigger Shire blocks, especially in Menai, Illawong, Engadine and Kirrawee. When a flat shares the main supply, the original mains often can’t carry both homes’ air conditioning and cooking. We check the combined load and either upgrade the mains on single phase or recommend three phase, whichever is right for the property.

Pools, spas and heat pumps

A pool is the single most common reason Shire owners call us about mains. Pool pumps, chlorinators, heat pumps and spa heaters add a big, long-running load. If you’re putting in a pool, have the mains checked before the pool electrician starts, so the supply is ready when the equipment is.

Get a fixed price

If your mains are original, warm or undersized, call your local level 2 electrician Sutherland Shire team for a free look and a fixed written price. We do this work every week across the Shire, including in level 2 electrician Miranda and Gymea.

Updated

The price depends on the cable run, how it gets from the bracket to the meter board (eave, wall cavity or conduit), whether the meter board moves and whether the bracket needs replacing too. We look first and give you a fixed written price.

What good consumer mains upgrade looks like

Close-up of consumer mains upgrade on a home in the Sutherland Shire area
What consumer mains upgrade looks like up close on a typical Sutherland Shire area home.
Signs that consumer mains upgrade needs attention
Typical signs that it needs attention.

Consumer Mains Upgrade questions in the Sutherland Shire

Something else on your mind? Call 02 9158 9999 and ask.

We're putting in a pool. Do the mains need upgrading?

Often. A pool pump and heat pump on top of ducted air and cooking can be more than older mains were sized for. We check your mains against the full load.

Our house is near the beach. Does that change anything?

It changes the fittings. We use galvanised hardware and sealed glands where the mains enter the meter box, because salt air corrodes standard fittings quickly.

Will the power be off all day?

Usually only a few hours. We tell you the timing before we start.

Need a Level 2 electrician in the Shire?

📞 Call now Free quote