Skip to content
Three phase meter board beside pool equipment at a Sylvania Waters home
Level 2 electrical

Three Phase Power Upgrade Sutherland Shire

More capacity for the way Shire homes run: pool, spa, ducted air, a workshop in the garage and a car on charge.

Get a free quote

Takes a minute. We'll call you back, usually the same day.

No obligation. Your details stay with us and are never sold or shared.

Three Phase Power Upgrade in the Sutherland Shire: step by step

  1. Add up the loadWe look at what you run now and what's planned, and tell you honestly whether three phase is the answer.
  2. Lodge the applicationWe apply to Ausgrid so they can confirm three phase supply at your address.
  3. Install three phase mainsNew mains go in and your retailer arranges the three phase meter.
  4. Connect and balanceWe connect all three phases, balance the load, test and certify.

The Shire lifestyle runs on power. A pool pump and heat pump, a spa, ducted air conditioning, an induction kitchen, a garage workshop with a compressor or welder, a big solar system and an EV on charge. Older Shire homes were connected on single phase supplies sized for a fridge, a hot water system and a few lights. A three phase power upgrade spreads the load across three phases so it can all run without tripping the main switch or straining the mains.

When three phase is worth it

  • You have, or are adding, a pool with a heat pump and ducted air
  • You want a fast EV charger alongside your other big loads
  • A granny flat is going in with its own air conditioning and cooking
  • Your workshop runs welders, compressors or machinery built for three phase
  • You’re rebuilding and the new home is designed around high loads
  • Your solar installer needs three phase for the system size you want

Sometimes a consumer mains upgrade on single phase is enough. If it is, we’ll tell you.

The Ausgrid step

Three phase starts with a connection application to Ausgrid. It confirms that three phase is available from the mains at your address, and whether any network work is needed first. Most Shire streets carry three phase on the overhead mains, and many estates from the 1980s onward have underground three phase reticulation. Some bush-edge streets and long private runs are different, and that changes the plan.

The work

Once approved, we install new three phase consumer mains from the point of attachment or boundary pit to the meter board. If the supply comes through a private pole, the private line may need upgrading too. Your retailer arranges the three phase meter, and your electrician fits the main switch and protection. On connection day we disconnect, connect all three phases, balance and test, and reconnect. You get a certificate of compliance.

Pools and three phase

Pools are the most common trigger for three phase in the Shire. A heat pump running for hours on a winter evening, while the ducted air and oven are on, is a big continuous load. If a pool is in your plans, check the supply before the pool electrician starts.

Rebuilds

On a knockdown rebuild, plan three phase from the start. We lodge the application early, so it’s approved before the house is finished. If you’re going underground, the three phase cable goes in the same trench with an overhead to underground conversion. Site power comes from a temporary builders supply.

How long it takes

Connection day is a single visit. The time is in the approval and the retailer’s meter change, so lodge early.

Working with your electrician

We handle the network side: application, mains, connection and certification. Your electrician does the switchboard and circuits. We coordinate so the connection happens on the day the board is ready.

Private poles and three phase

If your supply comes through a private pole, upgrading to three phase can mean upgrading the private line and the fittings on the pole too. On bush blocks, that’s often the moment owners decide to replace an ageing pole or take the supply underground, rather than spend money on equipment that’s near the end of its life.

Get a price

Call your Sutherland Shire level 2 electrician to check your supply and get a fixed written price. We do a lot of three phase work for waterfront homes in level 2 electrician Sylvania.

Updated

Three phase upgrades are priced on Ausgrid's requirements for your street, the new mains route, metering and the switchboard work your electrician does. We give a fixed price for the network side after we look.

What good three phase power upgrade looks like

Close-up of three phase power upgrade on a home in the Sutherland Shire area
What three phase power upgrade looks like up close on a typical Sutherland Shire area home.
Signs that three phase power upgrade needs attention
Typical signs that it needs attention.

Three Phase Power Upgrade questions in the Sutherland Shire

Something else on your mind? Call 02 9158 9999 and ask.

Our garage workshop has a welder and compressor. Do we need three phase?

If you run large motors or welders, three phase is often the right supply. Some machines are built for it. We check what you run and advise.

Can three phase help with a bigger solar system?

It can allow a larger inverter and different export limits, depending on Ausgrid's rules for your connection. Your solar installer will confirm what they need.

Is three phase available on our street?

Most Shire streets have it, but not all. The Ausgrid application confirms it before any work starts.

Need a Level 2 electrician in the Shire?

📞 Call now Free quote